Approximation by Non-Uniform Rational Basis Spline

Youssef Ali Alhendawi

Abstract


Bend or surface remaking is a testing issue in the fields of building outline, virtual reality, film making and information representation. Non-uniform sane B-spline (NURBS) fitting has been connected to bend and surface it is an adaptable technique and can be utilized to construct numerous complex numerical models. To apply NURBS fitting, there are two noteworthy troublesome sub-issues that must be comprehended: the assurance of a bunch vector and, the calculation of weights and the parameterization of information focuses. These two issues are very testing and decide the viability of the general NURBS fit. In this examination, we propose another strategy, which is a mix of a half and half enhancement calculation and an iterative plan (with the acronym HOAAI), to address these challenges. Our strategy are the accompanying: it presents an anticipated enhancement calculation for improving the weights and the parameterization of the information focuses, it gives an iterative plan to decide the bunch vectors, which depends on the figured point parameterization, and it proposes the limit decided parameterization and the segment based parameterization for disorderly focuses

Full Text:

PDF

References


J. Corney, "3D displaying with ACIS part and toolbox", John Wiley and children, Chichester, 1997.

J. Neider, T. Davis, and M. Charm "OpenGL programming guide", Addison-Wesley distributing organization, Reading, 1994.

J. Hoschek, and D. Lasser "Grundlagen der geometrischen Datenverarbeitung", Teubner, Stuttgart, 1989.

G. Farin, "Bends and surfaces hoschekfor PC supported geometric outline", Academic Press, Boston, 2. ed., 1990.

R. Fletcher, "Down to earth strategies for streamlining", John Wiley and Sons, Chichester, 2. ed., 1987.

B. Elsa¨sser, "Estimation mit rationalen BSpline Kurven und Fla¨chen", Ph.D. proposal, Darmstadt, 1998.

D. Jupp, "Guess to information by splines with free bunches", SIAM J. Numer. Butt-centric., pp. 328-343, vol 15, No. 2, 1978.

P. Laurent-Gengoux, and M. Mekhilef, "Advancement of a NURBS portrayal", Computer Aided Design, pp. 699-710, vol 25, No. 11, 1993.

C. de Boor, "A handy manual for splines", Springer, New York, 1978.

J. Nocedal, and S. Wright "Numerical Optimization", Springer Series in Operation Research, New York, 1999.

T. Schu¨tze, "Diskrete Quadratmittelapproximation durch Splines mit freien Knoten", Ph.D. theory, Dresden, 1998.

H. Schwetlick, and T. Schu¨tze, "Slightest squares estimate by splines with free bunches", BIT, pp. 361-384, vol 35, No. 3, 1995.


Refbacks

  • There are currently no refbacks.


Abava   IEEE FRUCT 2018

ISSN: 2307-8162